setup-osx-compiler-esp8266
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
setup-osx-compiler-esp8266 [2015/03/10 20:31] xjdkhq [esp-open-sdk] corrected typo |
setup-osx-compiler-esp8266 [2015/08/19 16:58] jseb [Dependencies] |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| brew install grep | brew install grep | ||
| brew install autoconf | brew install autoconf | ||
| - | brew install binutils (for gobjcopy) | + | brew install binutils |
| - | brew install gawk (required overwriting the non-gnu awk in my case) | + | brew install gawk |
| - | brew install autoconf | + | brew install wget |
| + | brew install automake | ||
| + | brew install libtool | ||
| + | |||
| + | binutils is needed for gobjcopy | ||
| + | |||
| + | gawk is required for overwriting the non-gnu awk in my case | ||
| | | ||
| If you get the error "configure: error: could not find GNU awk", run | If you get the error "configure: error: could not find GNU awk", run | ||
| Line 30: | Line 36: | ||
| ==== Dependencies ==== | ==== Dependencies ==== | ||
| - | sudo port install gsed gawk binutils gperf grep gettext py-serial | + | sudo port install gsed gawk binutils gperf grep gettext py-serial wget |
| | | ||
| ==== Get the compiler ==== | ==== Get the compiler ==== | ||
setup-osx-compiler-esp8266.txt · Last modified: 2017/03/13 22:41 by polarstate