What could be wrong? do i really need to flash these three files on the module? is there a single file with the firmware to flash on the module?
PS: i'm using esptool running on OS X to flash the module.
Thanks for your time.
Explore... Chat... Share...
sudo python esptool.py --baud 921600 --port /dev/tty.usbserial-A700fbUH write_flash -fm dio 0x000000 v184.108.40.206\ AT\ Firmware.bin
Running Cesanta flasher stub...
Flash params set to 0x0200
Writing 1044480 @ 0x0... 1044480 (100 %)
Wrote 1044480 bytes at 0x0 in 15.4 seconds (542.6 kbit/s)...
Hi all, If I run ESP.deepSleep(60000); my ESP[…]
Took me some time to figure it out. Here you go: […]
Well, 2.4.2 is working so far. Approaching three d[…]
Whenever you receive data, request for the sender[…]
Hello everyone, this is my first post here. I ha[…]
I would also pay attention to this software https:[…]
Option B worked :) but its funny that motor stop,w[…]
to get the relevant pins for ESP8266 look here: ht[…]
Why repeated mentions of GPIO15? Its GPIO0 that co[…]
Today i found more info on this so i am now more h[…]
So... I change my question. I have an esp module t[…]
hello I created this code please help, I mean afte[…]
When I said "see your code" I meant all[…]
Still failing. Any ideas?
I'm trying to update nodemcu from a password prote[…]
I resolved my question #2 quite simply actually. T[…]
Solved. The abort() occurs because I don't have th[…]
have you had a chance to work on this anymore? @er[…]
Hello; I too was very disappointed when buying t[…]
I am using the HSPI peripheral in master mode to t[…]